V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
-
Pre-drill holes in the middle of the drill markings on the inside of the bumper cover.
-
Use hole tool part no. 9997346 to make holes in the bumper cover. Check that the markings (1) are opposite each other when using the tool.
-
Make four holes in the bumper cover using the hole tool. Place the cutting part of the tool on the outside of the bumper cover.
-
Screw the hole tool together until it has cut the hole in the bumper cover.
-
Remove the plastic pieces from the hole tool and make the remaining holes in the same way.
