V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
Note! Do not pull on the cable harness.
Remove:
-
the 2 screws
-
the collision sensor.
Installing the collision sensor in the B-post
Install:
-
the collision sensor
-
the 2 M5 screws. Tighten. See: Tightening torque See: Body and Frame/Specifications
-
the connector
-
the B-post panel. See: B-pillar trim panel See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/B-Pillar Trim Panel.
Collision sensor C-post, replacing
Removing the collision sensor from the C-post
Remove:
-
the side cushion. See: Side pad See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat
-
the lower part of the panel on the C-post. See: C-pillar trim panel See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and
Repair/C-Pillar Trim Panel.
Note! Do not pull on the cable harness.
Slacken off the 2 screws.
Remove the collision sensor.
Installing the collision sensor in the C-post
Install:
-
the collision sensor
-
the 2 M5 screws. Tighten. See: Tightening torque See: Body and Frame/Specifications
-
the connector
