V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
Control Unit: Service and Repair
Active On-Demand Coupling Module
Active On-Demand Coupling Module
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information is always correct.
Preparatory work
Ignition off.
Wait 3-4 minutes after the ignition has been switched off to reduce oil leaks on removal.
Removal
Removing the differential electronic module (DEM)
Note! Clean the area around the control module thoroughly before beginning removal.
Position a container underneath the Active on Demand Coupling.
Disconnect the connectors for the control module and the oil pump.
Remove:
-
the 2 screws for the control module
-
the control module with the sealing plate and the cupped washer.
Removing components from the Active on Demand coupling
Remove the throttle valve and the temperature/pressure sensor from the coupling.
A = throttle valve.
B = temperature/pressure sensor.
Use a large pair of pliers for removal. Grip the end of the throttle valve. Hold the pliers stable and pull the valve straight out.
Remove:
-
the temperature/pressure sensor as above
-
The O-ring from the throttle valve seat in the Active on Demand Coupling housing.