V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
Push forward the final drive slightly, to create space at the front of the bushing.
Position the tools as illustrated.
Check that the threaded rod goes through the front punch completely, so that a full thread is obtained.
Centre the tools against the bushing and sub-frame and tighten the nut on the puller rod.
Press out the bushing.
Installation
Note! When using 951 2923 Hydraulic hole cylinder See: Tools and Equipment/951 2923 Hydraulic Hole Cylinder it may be necessary to regrip
on account of the cylinder's restricted stroke length, (release the cylinder and screw the nut in on the puller rod).
999 7334 Drift See: Tools and Equipment/999 7334 Drift , 999 7054 Adapter incl. 2x MC6C M6X12 See: Tools and Equipment/999 7054 Adapter incl.
2x MC6C M6X12 , 999 7132 Nut M12 See: Tools and Equipment/999 7132 Nut M12 , 999 7332 Drift See: Tools and Equipment/999 7332 Drift , 999
7336 Cone See: Tools and Equipment/999 7336 Cone , 951 2923 Hydraulic hole cylinder See: Tools and Equipment/951 2923 Hydraulic Hole Cylinder
, 999 7034 Connecting rod M12X400 See: Tools and Equipment/999 7034 Connecting Rod M12X400
Push forward the final drive slightly, to create space at the front of the bushing.
Mark up the bushing with a line as illustrated, it is extremely important that the bushing is install in the right position.
Place the bushing and tool as illustrated
Exercise care to centre the tool, tighten the nut on the puller rod and press in the bushing.
Check that the threaded rod goes through the front punch completely, so that a full thread is obtained.
Centre the tools against the bushing and sub-frame and tighten the nut on the puller rod.
