V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
Press the throttle valve and temperature/pressure sensor into place on the control module contacts. Place the cupped washer with the convex side
against the temperature/pressure sensor. Lubricate the sealing rings on the valves with oil, P/N 116 1641-4 (0.3 liters).
Installing the O-ring
Carefully check that the sealing surface on the control module and valve seats in the Active On Demand Coupling is clean. Ensure that there is no
trace of cloth or paper. Lubricate the new O-ring with oil, P/N 116 1641-4 (0.3 liters). Press the O-ring into place in its seat.
Installing the control module for the Active On Demand Coupling
Install the control module and the valves for the coupling, press the control module against the coupling housing while loosely installing the 2 screws
alternately. Tighten. See Tightening torque Connect the connectors to the control module and the oil pump. Fill the Active On Demand Coupling with
oil. Check the oil level. See Final drive, replacing. Erase any diagnostic trouble codes (DTC's).
Ordering software
