V70 L5-2.4L VIN 55 B5254S (1998)
Warning!
The gas spring is under high pressure and therefore must be push (arrow) carefully into position.
Push down bracket (1) with gas spring to install the next screw fingertight.
Use a large pair of pliers to compress strut and position bracket.
Install a new screw and washer. Finger tight.
NOTE:
The thin washer shall be located between the bracket and the gear/box motor.
Tighten the screw (3) to 8 Nm (6 ft.lb) and screw (2) to 10 Nm (7 ft.lb).
Installing the seats
7
Re-Install the front seat to the floor board.
CAUTION!
Ensure that no wires are pinched or/and chafing at any point.
Install screws for the seat and tighten to 48 Nm (35 ft.lb).
Reinstall all other recovered parts in reversed order.
Warning!
Check the seat belt for proper operation.
Carry out a test of the seats all adjustments, with attention to the height adjustment.
WARRANTY STATEMENT:
Claims may be submitted under the New Car Warranty when there is a documented customer complaint using claim type 01.
