V70 L5-2.4L VIN 55 B5254S (1998)
-
Front camshaft belt cover. Tighten to 12 Nm (8.85 lb ft)
-
Upper camshaft belt cover. Tighten to 8 Nm (5.9 lb ft)
-
Install the auxiliaries belt.
-
Servo reservoir. Wipe clean. Check the level and top up as necessary.
-
Expansion tank.
Note!
Ensure that hoses are correctly positioned.
-
Starter motor. Tighten screws at transmission. to 40 Nm (29.5 lb ft). Support bracket screw. Tighten to 25 Nm (18.44 lb ft).
-
Engine cooling fan (FC).
-
Relay bracket and fan shroud.
-
Canister purge (CP) valve, relays and connectors.
-
Air ducts
-
The trigger wheel. Tighten to 17 Nm (12.54 lb ft)
-
Camshaft position sensor housing and a new cover. Tighten the camshaft housing to 10 Nm (7.4 lb.ft)
-
The torque rod bracket and the upper torque rod. Tighten the bracket to 50 Nm (36.9 lb.ft) and torque rod to 35 Nm (25.82 lb.ft) and angle
tighten 90 degrees. Use bevel protractor 951 2050 .
-
Ignition coils cover. Tighten to 8 Nm (5.9 lb.ft)
-
Air cleaner (ACL) cover and intake air hose.
-
The battery negative terminal. Note when disconnecting/connecting the battery lead.
Test function
Checking motor
-
Checked engine function by test driving the engine.
-
Wipe clean and check engine compartment.
Replacing rear camshaft seal
Preparations
Remove