V70 L5-2.4L VIN 55 B5254S (1998)
Front Crankshaft Seal: Service and Repair
Special Tools:
-
Counterhold tool No. 999 5433, or equivalent
-
Drift tool No. 999 5455, or equivalent
NOTE:
-
For additional information on special tools and equipment used in this procedure, refer to Tools For Engine Service and Repair. See: Tools and
Equipment
-
If low oil pressure/oil pump faults are suspected take oil pressure reading. See: Engine Lubrication/Testing and Inspection
-
Carry out steps 1, 2 and 4 of Timing Belt Replacement. See: Timing Components/Timing Belt/Service and Repair
Procedure
1. Remove vibration damper:
-
Remove splashguard.
-
Remove vibration damper, use counterhold tool No. 999 5433, or equivalent.
2. Remove crankshaft belt pulley:
-
Use universal puller and two vibration damper bolts.
-
Tighten two screws by hand until they contact the pulley.
-
Install puller so that the claws pull the bolts (not the pulley).
NOTE: Make sure that the claws do not damage the pulley teeth.
3. If replacing front oil pump seal only:
-
Remove the old seal using a groove-cut chisel.
-
Clean mating surfaces.