V70 L5-2.4L VIN 55 B5254S (1998)
-
Raise sub-frame on hoist.
NOTE: Ensure that steering gear studs are located in holes in sub-frame!
-
Install frame and support plate bolts.
-
Tighten sub-frame bolts first to 105 Nm +120° and then support plate bolts to 50 Nm.
Use protractor gauge tool No. 951 2050, or equivalent.
-
Transfer hoist to right-hand side and repeat procedure.
29. Remove liking hook, liking beam and support rails.
-
Install:
Steering gear nuts (five).
Use new nuts!
Tighten to: 50 Nm
Bolt securing front engine mounting to sub-frame.
Tighten to: 50 Nm
-
On right-hand drive models:
Guard plate/subframe nut (A).
Tighten to: 50 Nm
30. Install:
-
Torque rod support in transmission.
Tighten later version to: 35 Nm + 40°.
-
Tighten early version with 8 mm screw to: 18 Nm + 90°
Use protractor gauge tool No. 951 2050, or equivalent.
NOTE: Use new bolts.
-
Both oil pipe brackets.
Tighten to: 25 Nm
-
Cable conduit on sub-frame.