V70 L5-2.4L VIN 55 B5254S (1998)
8. Install:
-
Retainer to cable harness grommet.
-
Gear position sensor bracket screw.
-
Selector lever.
Tighten to: 16 Nm.
-
Gear selector cable with washer and retaining clip.
Apply grease part No. 1161241-3, or equivalent, sparingly to lever arm pin.
9. Reinstallation of connector.
-
Reinstall sockets to connector.
-
Reconnect connector halves.
-
Ensure that rubber sleeve is in position.
-
Secure harness and rubber sleeve with cable ties.
-
Reinstall connector on transmission.
-
Reconnect connector.
-
Remember rubber seal.
10. Finishing work
-
Install control system.
Refer to steps 22 through 38 of Open The Control System. See: