V70 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Install a new spring nut (from the kit) in the front mounting for the CD changer and bracket if there is not already a welded nut there.
Applies to cars with rear acceleration sensors
-
Remove the acceleration sensor behind the left-hand wheel arch
-
Install the CD changer as above. At the same time, reinstall the acceleration sensor in the same rivet nut and screw as before. The sensor must be
above the bracket for the CD changer. Tighten to 24 Nm (18 lbf. ft.).
Note! The acceleration sensor must be securely installed with the connector turned upwards. If the sensor is not secure, movement may
result in false values. This could result in poor system performance when cornering for example.
Applies to all models
-
Position the CD changer and bracket behind the left-hand wheel arch. Tighten using new screws from the kit.
-
Remove the two clips (1). Remove the protective cover from the DVD reader.
-
Remove the three screws (1) holding the bracket with the DVD reader. Turn the bracket and DVD reader.
-
Applies to cars with RTI/DVD and without TV: Connect the DIN cable (2), which was connected to the CD changer in point 46, to the DVD
reader.
