V70 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Press the spoiler into place on the bumper cover in the join between the painted and unpainted sections of the bumper cover.
Install the rivets in the wheel arch, 1 on each side.
Note! If a spoiler has not previously been installed on the vehicle, a hole must be drilled using a - 5 mm diameter drill bit.Use the spoiler hole as
a template.
Install rivets on the underneath through the flexible hinge and through the holes in the bumper cover.
Install a washer at the top of the rivets. Tighten.
Bend up the flexible hinges at the front edge/bottom edge of the spoiler.
Install the rivets through the hinges in the drilled holes.
Note! If a spoiler has not previously been installed on the vehicle, holes must be drilled using a - 5 mm diameter drill bit.Use the hinge holes as a
template.
Finishing
Important information
