V70 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Remove the mounting screws in the upper row and the outer screws in the lower row
-
Remove the intake manifold by lifting it approximately 20 mm
-
Remove the nipple for the water heated crankcase ventilation.
Allow the crankcase ventilation hose to run through the intake manifold without disconnecting it from the flame trap.
Transferring components when replacing the intake manifold
-
Transfer the electronic throttle module.
-
Use a new gasket.
-
Tighten.
Installation
Installing the intake manifold and gasket
NOTE: Ensure that the gasket faces are clean.
Install:
