V70 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Remove:
-
the lever
-
the nut, lock washer and rubber seal from the gear-shift position sensor
-
the nut for the cable duct. Lift the cable duct to one side
-
the two screws for the gear-shift position sensor.
Carefully lift the sensor off the gear shift linkage rod.
Replacing the sealing ring for the gear shift linkage rod
Remove the old sealing ring. Use a small rounded off screwdriver.
Take care not to damage the rod.
Smear a little automatic transmission fluid on the new sealing ring. Install the ring. Use drift 999 5476 PUNCH See: Tools and Equipment/999 5476
Punch.
Installing the gear-shift position sensor
Tighten the sensor screws lightly.
Install the rubber washer, lock washer and the nut on the gear shift linkage rod connection.
Tighten the nut.
Lock the nut with the lock washer.
