V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Power Mirror Control Module: Service and Repair
Upper Electronic Module (UEM)/Rear View Mirror, Replacing
Replacing The Upper Electronic Module (UEM), Or The Rear View Mirror
Preparations
NOTE: Read off data from the control module before replacing the control module. Program this data back into the new control module.
Programmed data is read off via VADIS vehicle communication.
CAUTION: New software can only be ordered after the control module has been installed in the car. VADIS reads off the new control module identity
which is required to order the correct software.
Always check the control module and connector on the control module box for bent or damaged pins or sockets. This may have caused the fault.
Removing the control module
-
Remove the lens
-
Remove the 2 screws at the front edge
-
Press the 2 rear catches forward
-
Press two of the catches on one side inwards. Remove the bulb holder
-
Disconnect the 2 connectors
-
Disconnect the ground lead.
HINT: Only certain versions of the upper electronic module (UEM) have a ground lead.