V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Drill a - 4 mm (5/32") hole in the side member, through the front hole in the bracket
-
Remove the screw and the bracket
-
Remove any swarf. Rust-proof the hole edge.
Applies to the V70
-
Ensure that the cable harness, previously routed over the side member, is positioned as close to the rear crossmember as possible. This is to
prevent the cable harness being trapped by the floor support or the two support feet for the floor support
-
Reinstall the floor support. Tighten the floor support together with the bracket for the accessory electronic module. Use the three M6 screws.
Tighten the screws. Tighten to 10 Nm (8 lbf.ft.)
-
Position two new spacer washers between the front hole in the bracket and the floor support. Tighten using a new self tapping screw.
Applies to all models
Applies to cars equipped with a Diversity antenna amplifier
-
Wrap foam tape around the cable / wiring for the antenna amplifier.
Applies to all models
-
Take the accessory electronic module from the kit. Connect the cable and connector previously routed along the right-hand side member.
Applies to all models
