V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Remove:
-
the screw (1) from the right-hand side of the tailgate sill trim panel
-
the three screws (2) in the right-hand floor support
-
the floor support.
Applies to S60 and S80
-
Push the insulation panel to one side under the seat cushion on both sides
-
Route the new cable harness along the side of the cargo compartment and out into the passenger compartment as illustrated
-
Position the end of the cable with the two large grey connectors on the left-hand side of the car under the seat cushion by the cable duct
-
Route the cable harness from the left-hand cable duct under the seat cushion, along the wheel arch and out through the hole in the car body behind
the backrest. Then route along the wheel arch and rear crossmember over to the right-hand side of the car
-
Continue to route the cable harness along the right-hand side of the cable duct and forward into the car. Then route the cable out through the hole
in the car body behind the lower edge of the backrest. Continue to the existing ground terminals under the seat cushion
-
Secure the cable harness at the existing cable harnesses and cable duct. Use the tie straps (1) (from the kit)
-
Find the pre-routed grey connector (2) by the left-hand tail lamp. Connect the grey connector to the corresponding connector (3) from the routed
cable harness.
Applies to the V70
