V70 2.4 L5-2.4L VIN 61 B5244S (2001)
which is required to order the correct software.
Always check that the control module and control module box connectors do not have bent or damaged terminals or socket / sleeves. This may have been
the cause of the fault.
Removing the control module
This method of removal applies to both the driver door module (DDM) and the passenger door module (PDM).
The illustration shows the driver door module (DDM).
-
Ignition off
-
Remove the door panel
-
Remove the nut and screw holding the door module
-
Disconnect the connectors
-
Pry up the rear edge of the door module. Pull the door module backwards and upwards. Remove the door module from its mounting on the door
panel
-
Press up the door module.
To remove the upper panel, see Removing the upper panel.
Check
Check that the control module's connectors are intact.
Installing the control module
This method of installation applies to both the driver door module (DDM) and the passenger door module (PDM).
-
Position the door module in the hole on the door panel.
Check that the lower mounting for the door module is correctly located in the support on the door panel
-
Press the door module into place
