V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Ignition switch interlock
An interlock and security feature (ignition switch interlock) is mechanically connected to the ignition switch by a cable. The ignition switch interlock
is controlled by the position of the lock cylinder in the ignition switch and by the position of the gear selector. This means that the gear selector must
be in the P-position for the ignition key to be removed from the ignition switch. The ignition key must be turned to position I or II before the lever can
be moved from the P-position. The ignition switch interlock is used only in combination with shift-lock.
Park / neutral position (PNP) function
The gear-shift position sensor has a park / neutral position (PNP) function to prevent the engine being started with a gear selected. This function
prevents the engine being started unless the P or N positions are selected. This prevents the car from lurching forwards when started.
For further information, see Design and Function, central electronic module (CEM).
Adaptation data
There are two functions for adaptation in the transmission control module (TCM) software which can be activated:
-
Resetting adaptation - carried out after replacing internal components or the entire transmission
-
Adaptation function - This function helps the mechanic to adapt the transmission. It makes it easier to reset the function of the transmission after
repair or replacement of, for example:
^
the transmission control system
^
the transmission fluid
^
the entire transmission
^
the transmission control module (TCM).
When the adaptation function has been activated, the test drive instructions must be followed. The following shifts can be adapted:
-
1-2
-
2 - 3
-
3 - 4
-
4 - 5
-
N-D
-
5 - 4
-
4 - 3
-
3 - 2
-
2-1
-
N-R
-
Neutral Control engagement and disengagement, if equipped.
While the car is in this mode, the orange/yellow warning lamp in the center of the combined instrument panel is used to indicate when each shift has
been adapted to its target value.
When the orange/yellow warning lamp (triangle) flashes after each of the listed shifts, the adaptation is complete.
Note: The function is only available in certain software versions.
Adaptation of the transmission is activated via the VADIS vehicle communication socket.
