V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Remove the plug from the hole into the passenger compartment.
If the car has a rubber grommet without room for more cables
-
Replace the existing rubber grommet with the rubber grommet from the kit.
If the car has a rubber grommet with room for more cables
-
Cut the end off the spare rubber nipple and route the cable to the passenger compartment
-
Thread the rubber grommet on from the kit. Lubricate the cable to facilitate sliding on the rubber grommet. Use soap. Route the cable through the
hole. Press the rubber grommet into place
-
Ensure that the insulation sheath for the cable is positioned against the lead-in. Secure it using a tie strap.
-
Push the floor carpet to one side. Pull in the cable.
-
Locate the connector that was disconnected earlier
-
Release the catch
-
Install the cable end pins in the connector.
1. Blue (Blue, BL)
2. Green (Green, GN)
3. Violet (Violet, VO)
4. Yellow (Yellow, Y)
5. White (White, W)
6. Black (Black, SB).
-
Press the connector catch back into place.
