V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Insert a screwdriver in the hole on the reverse of the steering wheel, at right angles to the rear surface of the steering wheel
-
Insert a screwdriver as far as possible to determine the position of the end of the spring clip (1)
-
Position the end of the screwdriver on top of the spring clip
-
Pry the screwdriver upwards towards the upper edge of the hole (2) until the spring releases and one side of the steering wheel module springs out
and releases from the mounting
-
Turn the steering wheel 180°. Carry out the procedure on the other side
-
Turn the steering wheel to the neutral position.
-
Fold the steering wheel module out
-
Remove the two connectors (1) for the sender wiring on the airbag.
Note! The connectors are tightly secured. Do not use tools to disconnect the connectors.
-
Place the steering wheel module to one side.
Remove:
-
the screw (1). Remove the ground lead
-
the connector (2) for the horn and the keypads
