V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Remove:
-
the 2 screws (1)
-
the inlet hose
-
the hose clamp (2)
-
the connector (3)
-
the tie strap for the cable.
Remove the turbocharger (TC) control valve from the air cleaner (ACL) housing
Remove:
-
the plastic nut on the wheel arch side
-
the air cleaner (ACL) housing.
Replacing sensor cable, left-hand side
Insert a hand under the fuse box. Disconnect the cable from the clips on the brake cable.
Pull up the sensor until the connector for the new cable is up.
Remove the tape and connect the connector.
Install the cable in the clips on the brake cable.
Caution! The yellow markings on the cables must be in the clip.
Raise the car.
Installation
Note! For tightening torques, see: Tightening torque See: Brakes and Traction Control/Specifications/Mechanical Specifications/Tightening
Torque.
Installing the sensor and the cable
