volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Reset Procedure|Page 16296 > < Reset Procedure|Page 16294
Page 35
background image

Applies to cars from model year 2005- (V70 CH 459000-, XC70 CH 173000-)

-

Remove the clip (1) in the insulation panel and fold the panel aside, so that the DVD drive is uncovered.

Applies to cars up to and including model year -2004 (V70 CH -458999, XC70 CH -172999)

-

Remove the clips (1) in the insulation cover to the DVD drive and remove it.

Applies to cars up to and including model year -2004 (V70 CH -458999, XC70 CH -172999)

-

Take the cable harness for power supply from the kit. Connect the ground lead to the rear ground terminal (1) under the seat cushion. Tighten to 10
Nm (7 lbf.ft.)
.

-

Route the power supply cable on the right-hand side of the air duct (2), under its cables, up along the top of the wheel arch and to the left-hand
side of the cargo floor support and position the red/white (R/W) single cables and the two green connectors by the rear fuse holder.

Reset Procedure|Page 16296 > < Reset Procedure|Page 16294