volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Removal and Replacement|Page 17987 > < Removal and Replacement|Page 17985
Page 7
background image

-

Press the door control module into place. Tighten using the screws.

-

Reinstall the cable in the clamps. Connect the cable connector to the treble loudspeaker.

Applies to the passenger door:

-

Reinstall the panel by the power window button.

Applies to both front doors:

-

Connect the connectors to the door control module. Reinstall the mechanical cable for the door opener.

-

Reinstall the door panel, according to point 1.

Applies to the rear doors:

-

Push in the centre of the clips (1). Remove the clips.

-

Remove the blind cover plug (2) and the screw from under it.

-

Remove the screw (3) in the door opener (4).

-

Disconnect the door panel (5). First slide the panel upwards and unhook the top edge.

-

Remove the connector (1) for the door control module.

-

Pull the door opener handle (3). Remove the mechanical cable (2) on the reverse. First pry up the locking lugs.

-

Remove the door panel.

-

Remove the six lock facings (1) holding the trim strip at the door panel. Use a screwdriver to pry up the lock facings slightly. Cut off the lock
facings using cutting pliers.

Removal and Replacement|Page 17987 > < Removal and Replacement|Page 17985