V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Illustration B applies to the XC70
-
If the guide lugs (3) and clips (4) have loosened - reinstall them.
-
Applies to cars with parking assistance: Lift up the bumper in position. Pull the cable for the sensors through the hole for the bumper's guide, and
pull the cable in from the inside.
-
Reinstall the bumper by pressing it forwards. Ensure that the four screws protruding from the bumper align with the holes in the car.
-
Before the bumper is completely installed, slide the top edge (1) into the grooves. Then slide the bumper fully in.
-
Check that the guide lug (3) and clip (4) are centred with the hole (2) in the wheel arch lining.
-
Tighten the screw (1) on both sides.
-
Rivet (2) the bumper into place as illustrated.
-
Only applies if the car is equipped with clips and mouldings: Reinstall the clips underneath the bumper. This is to secure the bumper to the
mouldings. (See step 5). Ensure that the clip locks are in the normal position.
-
Reinstall the nuts. Tighten to 18 Nm (14 lbf.ft) (see step 3).
-
Connect the antenna connector.
Applies to cars with rear mudflaps
-
Rivet the mudflap into place (see step 4).
-
Reinstall the wheels and tighten the screws alternately to 140 Nm (104 lbf.ft).
Applies to cars with lining mats with four perforations