V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Note! The new brake pipe must be bent into the correct shape when installing.This is important otherwise the pipe may be subject to stresses
when it is in place.
Remove the brake pipe from its clips
Raise the car
Remove the left front wheel.
Remove the screw from the bracket for the brake pipe and brake hose.
Remove the holder from the brake pipes.
Clean the brake pipe and joint nipple.
Separate the brake pipe at the joint nipple. Counterhold the joint nipple.
Remove the brake pipe from its clips.
Cut the brake pipe at the bracket. Leave the pipe that has been cut in place as a guide for installation of the new brake pipe.
Install the new brake pipe