V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Lubricate the seal using Volvo quality engine oil.
Install:
-
install the new seal for the intake camshaft. Use drift 999 5719 Drift See: Tools and Equipment/999 5719 Drift
-
the new seal for the exhaust camshaft. Use drift 999 5718 Drift See: Tools and Equipment/999 5718 Drift.
Checking and adjusting the variable valve timing unit
Check and adjust the variable valve timing unit. See: Variable valve timing unit, checking and adjusting, B5244T5, B5254T2 See: Testing and
Inspection.
Installing components
Install:
-
the trigger wheel. Tighten the screw
-
the camshaft position (CMP) sensor housing. Tighten the screws
-
the cover at the rear edge of the intake camshaft
-
the engine stabilizer brace on the cylinder head. Tighten. For tightening torques, see Tightening torque See: Specifications/Mechanical
Specifications/Tightening Torque.
Install:
-
the front timing belt cover
-
the cover over the ignition coils
-
the upper timing belt cover
-
the auxiliaries belt
-
the expansion tank
-
the servo reservoir. Check that the hoses are correctly positioned
-
the starter motor. Tighten the screws at the gearbox unit. See Tightening torque See: Specifications/Mechanical Specifications/Starting and
Charging
-
the charge air pipe between the charge air cooler (CAC) and the throttle body (TB)
-
the inlet hose for the turbocharger (TC) from the air cleaner (ACL) cover
-
the charge air pipe above the engine. Remove the seals
-
the engine stabilizer brace between the suspension turrets.
Finishing
