V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Sealing the cover
Check that the mating surface for the cover is level.
Wipe the cleaned mating surfaces on the cover and transmission.
Use denatured alcohol.
NOTE: Ensure that no dirt gets into the transmission.
Apply a bead of sealing compound, approximately 3 mm thick, to the cover. P/N 1161409-6. Apply the compound around the screw holes.
Installing the control system cover
Reinstall the control system cover on the transmission. Tighten the screws alternately. Tighten to 12 Nm. Torx TX 40.
Stretch the cable up to the oil temperature sensor.
Install:
-
the oil pipe on the transmission with a new O-ring