V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Place a container underneath the transmission.
Drain the oil. Measure and note the volume of oil. Then tighten the plug. Tighten to 40 Nm.
Remove the cable harness clamp on the control system cover.
Disconnect the ground lead from the transmission. Tie up the cable harness and ground lead.
Disconnect the oil cooler return line from the control system cover.
Disconnect the oil cooler pipe and hose from the transmission. Move the pipe to one side.
Seal the hole in the transmission with a plastic plug.
Removing The Control System Cover
Remove the Torx TX40 screws for the control system cover. Clean the sealing compound from the threads. Use tap M8 x 1.25.
Remove the cover. Use gasket wedge 999 5477 . Carefully tap it in between the cover and transmission so as not to bend the seal flange on the cover.
Clean the gasket residue from the cover and the transmission.
NOTE: Ensure that no debris enters the transmission. Wash the cover thoroughly.
Removing The Cable Harness
