V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Remove:
-
the screw from the rear edge
-
front edge from the hook on the member and remove the base section.
Installation
-
Position the bottom section and the air intake on the air pipe at the windshield washer fluid filler pipe.
Exposing And Removing The Relay Box In The Passenger Compartment
Exposing And Removing The Relay Box In The Passenger compartment
CAUTION: The customer-programmed data must be read off before the control module is replaced. The information must then be entered
into the new control module after it has been installed. This is carried out via VADIS vehicle communication.
NOTE: For cars with Volvo On Call (see the carphone keypad), the battery negative lead must be disconnected first. Otherwise an automatic alarm call
may be made to the emergency services.
NOTE: The driver information module must not be replaced at the same time. This would erase the mileage.
CAUTION: New software can only be ordered after the control module has been installed in the car. VADIS reads off the new control module
identity which is required to order the correct software
NOTE: Key codes must be programmed before the central electronic module will accept the keys that belong to the car. This is carried out in "Add /
Remove keys" via VADIS vehicle communication.
