V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
-
Loosely install both the screws retaining the spring strut in the wheel spindle. Use new screws and nuts.
-
the tie rod end onto the wheel spindle. Use a new nut. Tighten to 70 Nm.
Install
-
Adjust the position of the wheel spindle and spring strut. See Wheel knuckle / spring strut, calibrating . Tighten to 105 Nm. Angle-tighten 90°.
Use bevel protractor 951 2050
-
the anti-roll bar link to the spring strut. Use a new nut. Tighten to 50 Nm. Counterhold with a Torx wrench so that the boot is not damaged
-
the ABS sensor cable
-
ABS sensor onto the wheel spindle. Tighten the ABS sensor. Tighten to 10 Nm.
Note: Ensure that the sensor seat in the wheel spindle is completely clean. Clean the ABS sensor with a soft brush.
-
the brake disc. Tighten the brake disc locating pin. Tighten to 8 Nm.
Note: Ensure that the brake disc and wheel rim hub mating surfaces are clean.
Tighten the drive shaft screw. See Tightening torque. Use a screwdriver as a counterhold on the brake disc.