V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Remove the pipe coupling at the steering gear.
Pull the pipe/hose towards the right wheel arch until the end with the nipple can be pulled forward.
Remove the hose.
Note! Make a note of the routing of the hose.
Installing the return hose
Route the hose through the engine compartment.
Pull the pipe/hose towards the right wheel arch until the end with the nipple can be slid backwards to the correct position.
Thread the nipple into the steering gear (use a new O-ring).
Install:
-
the clip on the pipe over the steering gear
-
the tie strap around the pipe where the return hose meets the pressure hose
-
the screw for the clamp on the sub-frame (does not apply to AWD).
Tighten the nipple in the steering gear. Tighten to 25 Nm.
Install:
-
the heat deflector plate over the steering gear
-
the splash guard under the engine
-
the three-way catalytic converter (TWC) mounting member
-
the SIPS (side impact protection system ) member.
Lower the car.
Install:
-
hose on the fluid reservoir (Use a new Oetiker clamp)
-
the clips (3x) for the cable harness
-
the tie strap by the torque rod mounting.
Finishing
