V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Suspension Strut / Shock Absorber: Testing and Inspection
Wheel Knuckle / Spring Strut, Calibrating
Measuring before removal
The measurements are made so that the same camber angle can be obtained when installing.
Measure over the wheel spindle / spring strut at the upper screw as illustrated.
Before measuring clean off any dirt from the measuring surfaces.
Note the measurement.
Installing the spring strut / wheel spindle
Install the spring strut on the wheel spindle. Use new screws and nuts.
Adjust in accordance with the measured values.
Tighten to 105 Nm. Angle-tighten 90°. Use bevel protractor 951 2050.
