V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Note: The flange on the lower rear screw must be ground off as illustrated before it can be removed from the wheel spindle.
Installing the rear wheel hub
(The illustration displays the rear wheel hub schematically)
Note: Ensure that the hub and the wheel spindle mating surfaces are clean.
Install
-
the rear wheel hub. Use new screws and torque wrench with ring wrench kit. Tighten crosswise. Tighten to 20 Nm.
Then tighten to 65 Nm.
Finally angle-tighten 60°. Use bevel protractor 951 2050.
Note: The screw without a flange has a washer which is included in the kit. Position the screw in the rear lower screw hole.
-
the brake disc
-
the locating pin for the brake disc. Tighten the locating pin.
Tighten to 10 Nm
-
the brake caliper. Use new screws. Tighten to 60 Nm
-
the ABS sensor.
