V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Installing the new primary shaft seal
Lubricate the lip of the primary shaft seal. Use grease, P/N 1161241-3.
Use the drift 999 7004 Drift primary shaft seal M56 See: Tools and Equipment/999 7004 Drift Primary Shaft Seal M56 when installing the primary
shaft seal.
Pull the sliding drift sleeve forward. Press the seal into place.
Guide drift on primary shaft. Tap in the seal until the sliding drift sleeve is against the gearbox and in the rear sleeve position.
Installing the clutch cylinder
Tighten the screws. Tighten to 10 Nm.
Thread the rubber seal onto the pipe with the boot turned towards the clutch cylinder.
Remove the protective plug. Install the junction. Always use a new quick-release connector with a rubber seal.
Lubricate the rubber seal using a drop of brake fluid. This facilitates joining.
Press the pipe into the junction. Lock the pipe using the clip.
Installing the rubber seal for the pipe in the clutch cover
Ensure that the rubber seal locates all the way around.
Note! Follow-up work: Install the transmission.