V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
Remove the nut for the lower ball joint and control arm. Clean the exposed threads outside the nut. Spray using rust solvent before removing the nut.
Counterhold with Torx TX 40 at the ball joint pinion when removing the nut. This is so that the ball joint boot does not turn.
Remove the nuts for the anti-roll bar links. Unhook the links from anti-roll bar.
Removing The Bracket For The Power Supply Cable For The Heated Oxygen Sensor (HO2S)
Remove the screws for the bracket.
Applies only to right-hand drive cars
Remove the front cross member
Remove:
-
the screws for the cross member
-
the screws for the rubber mounting
-
the brake pipe from its holders.
Removing the steering gear from the sub-frame
Remove:
-
the nuts and screws for the steering gear
-
the screw for front engine pad and sub-frame
-
the screws securing the torque rod mounting on the transmission.
Unhook the power steering fluid line from the sub-frame.
Removing the screws from the sub-frame support brackets (both sides)
