V70 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2002)
-
new lock nuts and screws on the steering gear. Tighten to 50 Nm
-
the screw for the front engine pad. Tighten to 50 Nm
-
new screws for the torque rod mounting. Tighten to 35 Nm and angle tighten +40 degrees.
Press the power steering line into the holders on the sub-frame.
Installing the nuts securing the ball joint to the control arm and the anti-roll bar to the link rods
Install the nuts for the ball joint and control arm: Counterhold with a Torx wrench so that the boot does not rotate. Tighten to 80 Nm.
Install the anti-roll bar and link rods: Use new nuts. Tighten to 50 Nm.
Installing the bracket for the heated oxygen sensor (HO2S)
Applies only to right-hand drive cars
