V70 2.5T L5-2.5L Turbo VIN 59 B5254T2 (2006)
-
Unscrew the screws and remove the large panel on the left and right-hand sides. Only the left-hand one should be removed on right-hand drive
cars.
Installing the cable harness from the bumper
Illustrations 15-20 show a left-hand drive car.
For right-hand drive cars: carry out the corresponding procedure on the left-hand side of the car.
-
Take the short cable harness from the kit.
-
Detach the smaller connector from the cable.
-
Fit the waterproofed connector (1) with plastic clamp / metal clip from the kit.
-
Secure the plastic clamp around the connector and install the metal clip around the panel edge on the right-hand side of the car.
-
Pull the end of the cable with the loose pins into the engine compartment.
-
Route the cable (1) as illustrated. Place it under the fuse holder and expansion tank so that it is concealed.
-
Make sure that it is positioned so that it is not damaged by heat or wear.
-
Clamp it in with tie straps from the kit.
Cable routing to the passenger compartment