V70 2.5T L5-2.5L Turbo VIN 59 B5254T2 (2006)
-
Measure out and make hole markings for the sensors' connectors 30 mm to the right of the inner holes.
-
Drill out the six holes in the inner plastic using a 50 mm diameter hole saw. The four inner holes are also drilled through the foam.
-
Remove the foam.
-
Cut out for the sensors' cables straight up in the foam from the holes which were opened up for the sensors' connectors, to the right of the inner
holes.
Hole drilling (applies to the XC70)
Removing the skid plate
-
Drill out the five blind rivets in the lower edge of the skid plate using a -6 mm diameter drill bit.
-
Press in the ten catches holding the skid plate to the bumper cover.
-
Remove the skid plate from the bumper cover.
Drilling holes in the skid plate
Note! The illustration shows the right-hand side. The corresponding work is also carried out on the left-hand side.
-
Measure out for the sensors' holes in the skid plate as illustrated.
