V70 2.5T L5-2.5L Turbo VIN 59 B5254T2 (2006)
-
Use assembly tools and blind rivets with spacers from a separate kit.
Illustration B
-
Attach the skid plate to the bumper cover.
-
Install the four blind rivets.
Installing the sensors and cable harness
Note! The illustration shows installation on a left-hand drive car.
-
Take the sensors and their cable harness from the kit.
-
Install the two sensors in the sensor holders so that they are securely fitted. The outer sensors are installed from below after the bumper has been
reinstalled on the car.
-
Attach the cable harness' connectors to the inner sensors. Make sure that the detached sensors in the outer position have sufficient cable to be
installed after the bumper cover is fitted into place. The cable harness' detached connector should now appear on the side of the bumper.
Note! When installing on right-hand drive cars the cable harness connector must come out on the left-hand side of the bumper.
