V70 2.5T L5-2.5L Turbo VIN 59 B5254T2 (2006)
-
First, pull the boot lid sill trim panel (4) forwards until the two clips on the right-hand and left-hand sides release. Pull forcefully but carefully
since the panel is fitted tightly. Pull the panel straight up until the four clips in the lower edge release.
-
Remove the wiring (5) for cargo compartment lighting.
-
Lift out the sill trim panel.
-
Remove the drain hose (1) from the battery.
-
Remove the rubber seal (2). It will not be re-used.
-
Pull off the small, thin rubber strap on the new rubber seal.
-
Insert the old drain hose through the new rubber seal. Make sure the hose is not obstructed and that it is not folded.
Note! It is only possible to connect one of the functions (rear fog lamps, charging or reversing lamps) according to steps Tow bar wiring, 7-pin
See: - Tow bar wiring, 7-pin See: . You can also choose not to connect any of the functions.
Part 2
Tow bar wiring, 7-pin (Continued)
If the rear fog lamp function will be used: Illustration A
-
Carefully press down the small catch in the locking mechanism for the grey (GR) 12-pin connector with a small screwdriver. Pull out the locking
mechanism until it stops.
Illustration B