V70 2.5T L5-2.5L Turbo VIN 59 B5254T2 (2006)
-
Carefully press out the blue locking mechanism in the black 12-pin connector with a small screwdriver.
Illustration B
-
Connect the black/yellow (SB/Y) cable to position H in the black (SB) 12-pin connector.
-
Move the locking mechanism back to locked position.
-
Insulate the cable terminal on the unused blue/yellow (BL/Y) cable and secure the cable to the cable harness. If neither cable is intended for
connection, insulate and secure both cables.
Illustration A
-
Route the cable harness from the tow bar connector through the hole in the floor.
-
Adjust the position of the rubber seal (1) so that there is not excessive cable slack under the car.
-
Install the rubber seal in the hole.
-
Connect the drainage hose (2) to the battery.
-
Route the cable harness as shown in the illustration over the rear edge of the left-hand side member to the fuse holder.
Illustration B
