V70 2.5T L5-2.5L Turbo VIN 59 B5254T2 (2006)
-
Tighten the screw (1) on both sides
-
Rivet (2) the bumper into place as illustrated.
Only applies if the car is equipped with clips and mouldings
-
Reinstall the clips underneath the bumper. This is to lower the bumper towards the mouldings. Ensure that the clip locks are in the normal position.
Applies to all cars
-
Reinstall the nuts. Tighten the nuts. Tighten to 18 Nm (13.5 lbf.ft.)
-
Connect the antenna connector.
Applies to cars with mudguards
-
Rivet the mudguards
-
Reinstall the wheels. Tighten the nuts crosswise. Tighten to 140 Nm (104 lbf.ft.).
Applies only if the car has a lining mat with four perforations
-
Install the rubber tabs (from the kit) as follows:
Align the rubber tabs (1, 4) edge to edge with the lining mat
Compress the rubber tab (2) slightly to align in the cut out
Align the rubber tab (3) so that the lower edge is positioned edge to edge with the lining mat. Cut off the section protruding over the lining mat. (Do not
cut off an excessive amount).
Applies only if the car has a lining mat with one perforation
-
Install a new lining mat.
-
If necessary, cut away the area (1) around the screw heads so that the screws are accessible.
-
Check the function of the detachable tow hitch.
Illustration A applies to installation of the tow hitch
