V70 2.5T L5-2.5L Turbo VIN 59 B5254T2 (2006)
-
Remove the six lock facings (1) holding the trim strip at the door panel. Use a screwdriver to pry up the rear lock facings slightly. Then cut the
lock facings using cutting pliers. Use the bent section of a double ended scriber to pull up the front lock facings slightly (sunk in the plastic panel)
to cut off them off.
-
Remove the trim strip. First pull the door opener handle. Pull off the trim strip.
-
Install the new trim strip on the door panel. Press the trim strip into place
-
Create a counterhold on the trim strip using a soft, clean rag. This is to prevent damage. At the same time install locking washers on the lugs (1) on
the reverse of the door panel. Securely press the locking washers into place as illustrated. NOTE! Do not damage the door panel and trim strip.
Applies to both front doors:
-
Reinstall the loudspeaker grille
-
Reinstall the inner handle for the door. Screw the door handle into place
-
Press the door control module into place. Tighten using the screws
-
Reinstall the cable in the clamps. Connect the cable connector to the treble loudspeaker.
Applies to the passenger door:
-
Reinstall the panel by the power window button.
