V70 2.5T L5-2.5L Turbo VIN 59 B5254T2 (2006)
Press out the wheel spindle. Detach the drive shaft from the hub. Do not damage the drive shaft boot. Use a tensioner band to pull the spring strut
backwards. Remove the screws from the bearing cap for the drive shaft.
CAUTION: Do not pull the outer part of the shaft. Doing so could damage the axial stops in the joints.
Pull the drive shaft straight out.
Removing The Propeller Shaft
Mark the propeller shaft CV joint in relation to the bevel gear flange.
Remove the screws from the propeller shaft. Use: 999 7057. Press the drive shaft joints together as much as possible. Remove the shaft from the bevel
gear. Leave the end of the shaft resting against the anti-roll bar.
Removing Bevel Gear