volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Procedures|Page 4172 > < Procedures|Page 4170
Page 1
background image

Fluid - A/T: Removal and Replacement

Resetting Transmission Fluid Change Counter

Resetting Transmission Fluid Change Counter 

HINT:  The transmission control module (TCM) has a counter for the oil quality. The counter counts up if the transmission is exposed to too high a load
or an ambient temperature that is too high. If the counter is not reset when the oil is drained or changed, there is a risk that a diagnostic trouble code
(DTC) will be stored in faulty circumstances. Therefore it is important that the "Transmission oil change" counter is reset.

NOTE:  This applies only when the transmission fluid is changed and when the fluid is changed when repairs are carried out to the transmission
temperature sensor.

-

Ignition on.

Reset the counter by clicking on the VCT 2000 symbol.

Continue:  Refer to Diagnostic Trouble Code Descriptions.

Transmission Fluid, Replacing

Transmission fluid, replacing

Warning! Avoid skin contact with the transmission fluid.

Note! Use only transmission oil, Volvo P/N 116 1540-8 (1 liter container), 116 1640-6 (4 liter container).

Conditions

The oil should be replaced only in the two following instances:

Where diagnostic trouble codes (DTCs) TCM 0042 and TCM 0046 are stored, in which case the diagnostic function activates the warning lamp in the
following circumstances.
The transmission control module (TCM) receives data about the operating temperature of the transmission fluid while the car is being driven. TCM 0042
is stored after an accumulated amount of time.
Diagnostic trouble code (DTC) TCM 0046 is stored if the transmission fluid temperature exceeds 150° C for more than two minutes.
In cars used in continuous taxi service or used for towing a trailer or caravan for most of its mileage, the oil must be replaced at a service interval of 75,
000 km ± 5000 km. This is to conform to the regular service program.

Procedures|Page 4172 > < Procedures|Page 4170