V70 2.5T L5-2.5L Turbo VIN 59 B5254T2 (2006)
-
Remove the side panel on the right-hand side by first removing the cover and screw in the front edge.
-
Pull the top edge of the panel out until the clips release.
-
Pull the seatbelt from the holder (1).
-
Remove the seatbelt cover (2) by bending away the catches on the underside and pulling the cover up.
-
Fold the panel inwards. Lift the panel out.
-
Take the right side panel and drill out the hole for the 12V socket in the marking in the upper rear corner on the lower section of the panel.
-
Pre-drill the hole using a dia 3 mm (1/8") bit.
-
Drill out the hole using a dia 27 mm (1 1/16") diameter hole saw.
-
File out the hole with a round and square file.
-
Install the 12V socket in the panel.
-
Fit the nut on the 12V socket on the rear side of the panel and tighten.
-
Identify the routed cable located by the right-hand floor support. Plug in the connector.
Reinstall:
-
the side panel. Make sure that the cable to the 12V socket is not trapped when it is installed.
-
the folding hatch.
-
the storage box.
-
the rear floor hatch
Only applies to cars with an auxiliary rear facing seat
-
Reinstall the side panel. Make sure that the cable to the 12V socket is not trapped when it is installed.
-
Reinstall the seatbelt cover.
-
Guide the seatbelt into its holder.
-
Reinstall the side floor hatch.
-
Reinstall the trough.