V70 2.5T L5-2.5L Turbo VIN 59 B5254T2 (2006)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
Thermostat / Temperature Sensor, Engine Coolant, Replacing
Thermostat / temperature sensor, engine coolant, replacing
Special tools:
951 2885 Sleeve See: Tools and Equipment/951 2885 Sleeve
999 5722 Wrench See: Tools and Equipment/999 5722 Wrench
999 7109 Wrench See: Tools and Equipment/999 7109 Wrench
951 2953 Cover See: Tools and Equipment/951 2953 Cover
951 2957 Coolant Reservoir See: Tools and Equipment/951 2957 Coolant Reservoir
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Removing / installing
Removing the engine coolant temperature (ECT) sensor
Remove:
-
the upper timing belt cover. Disconnect the connector for the temperature sensor
-
the temperature sensor from the thermostat housing. Use 951 2885 Sleeve See: Tools and Equipment/951 2885 Sleeve.
Note! Put paper underneath the sensor to prevent coolant spillage.
Installing the engine coolant temperature (ECT) sensor
Install:
-
the sensor with a new seal. Tighten. See: Tightening torque See: Engine, Cooling and Exhaust/Engine/Specifications/Tightening Torque. Use: 951
2885 Sleeve See: Tools and Equipment/951 2885 Sleeve
-
the upper timing belt cover.
Removal
Preparation