V70 2.5T L5-2.5L Turbo VIN 59 B5254T2 (2006)
Position the cable harness in the sealing ring socket and in the mounting on the body (arrow in photo).
Install the floor hatch. Tighten to 6 Nm (4.5 lb. ft.).
Carefully check that the seal is in place when the hatch is installed.
New PEM installation
The new PEM is to be positioned on the rear part of the spare wheel well on the right side between the two stampings and below the bead of sealant, as
shown in the photo.
Remove the backing tape from the self-adhesive Velcro strap and install the PEM. Connect the cable's connector from the cable harness to the PEM.
Finishing work
Reposition the insulating mat.
Install:
-
the child seat bracket to the floor.
Use new screws:
-
1 M1O tightened to 50 Nm (37 lb. ft.)
-
1 M12 tightened to 80 Nm (60 lb. ft.).
-
the backrest. Use new screw:
-
1 M10, tightened to 50 Nm (37 lb. ft.)
-
side cushion
-
seat cushion
-
cargo compartment carpeting/floor hatches.
Warranty Claim Information
