V70 2.5T L5-2.5L Turbo VIN 59 B5254T2 (2006)
-
Clean the inside of the bumper cover using a mild soap solution.
-
Clean around the holes and their inner edges using a cleaning cloth. Allow to dry.
-
Apply a thin layer of activator (P/N 8637076) on the cleaned surfaces. Allow to dry.
-
Clean the sensor surface (1) on the sensors, and the surfaces (2) and (3) on the sensor holders. Use a cleaning cloth. Allow to dry.
-
Apply a thin layer of activator on the cleaned surfaces and allow to dry.
Illustration A
-
Remove the protective backing tape from one side of the tape.
-
Affix the tape to the front side of the sensor holders (see illustration B).
-
Carry out the procedure above for the three other sensor holders.
-
Check the marking on the rear side (A) of the sensor holders for the correct location.
Illustration B